Ibm-partner-pavilion Remote Supervisor Adapter Manual do Utilizador descarregar pdf (Página 93)

MNP microcom networking protocol

RTS ready to send

Configuring network interfaces

With the network interface options, you can set access to the Remote Supervisor

Adapter by:

v Configuring an Ethernet connection to a Remote Supervisor Adapter

v Configuring point-to-point protocol access over a serial port

Configuring an Ethernet connection to the Remote Supervisor Adapter

Complete the following steps to configure your Ethernet setup:

1. Log in to the Remote Supervisor Adapter. For more information, see

“Accessing the text-based interface through a Telnet connection” on page 65 or

“Accessing the text-based interface through a direct serial connection” on

page 66.

2. In the Advanced System Management window, select Settings. The Settings

window opens.

3. In the Settings window, select Network Interfaces/Protocols. The Network

Interfaces/Protocols window opens.

4. Select Ethernet. A window similar to the following opens.

Chapter 7. Configuring your Remote Supervisor Adapter using a text-based interface 87

1 2 ... 88 89 90 91 92 93 94 95 96 97 98 ... 123 124

Sem comentários

Ibm-partner-pavilion Remote Supervisor Adapter Manual do Utilizador Página 93